EXCLUSIVE !

CALMINI Nissan TX-10 Rockcrawler Gearset

Finally, a true ROCKCRAWLER transfer case gear set for for the Nissan 4x4! Our gear set is manufactured in the USA from SAE 8620 alloy bar stock material. For long wear life and operation at high speeds nothing else is acceptable. This gearset provides a final low range reduction of 3.92:1, which is a whopping 93.86% lower than stock!  It completely transforms this vehicle's off road crawl capability and enables it to perform much better in heavy off-road use situations.  This gearset will fit all Nissan TX-10 transfer cases available in all Nissans worldwide.  The complete gearset comes with precision machined counter-gear, input gear, and output gear, billet machine retainer ring and bearing as well as two(2) quarts of Valvoline 80W90 gear oil and Permatex RTV silicone gasket maker. 

FREE WITH ANY GEARSET ORDER THROUGH APRIL 30, 2005

The CALMINI Slip Yoke Eliminator kit allows you to use a 2 piece rear driveshaft on your Nissan.  Will all for a Spicer 1310 & 1330 U-joint or C.V. Joint patterns. Complete kit comes with assembled slip yoke eliminator, four(4) Grade 8 driveshaft mounting bolts, one(1) Grade 8 output shaft mounting bolt, lock washers, and Loc-Tite.  Minor modification to rear output shaft required. Comes complete with installation instructions for an at home install.